4.3.3. Cone operator¶
Like the Slice operator, the Cone operator is also a slice operator. The Cone operator slices a 3D database with a cone, creating a surface that can be left in 3D or be projected to 2D. Plots to which the Cone operator has been applied become surfaces that exist on the surface of the specified cone. The resulting plot can be left in 3D space or it can be projected to 2D space where other operations can be done to it. A Pseudocolor plot to which a Cone operator has been applied is shown in Figure 4.16.
126.96.36.199. Specifying the slice cone¶
You can specify the slice cone by setting various fields in the Cone attributes window, shown in Figure 4.17. To specify how pointy the cone should be, type a new angle (in degrees) into the Angle text field. The cone is defined relative to its origin, which is the point at the tip of the cone. To move the cone, type in a new origin vector into the Origin text field. The origin is represented by three floating point numbers separated by spaces. Once the cone is positioned, you can set its direction (where the cone points) by entering a new direction vector into the Direction text field.
The cone can extend forever or it can be clipped at some distance along its length. To clip the cone at a certain length, check the Cut cone off check box and enter a new length value into the Length text field.
188.8.131.52. Projecting the slice to 2D¶
The Cone operator usually flattens sliced plots to 2D along the cone’s direction vector. This results in circular 2D plots in the visualization window. The Cone operator can also unfold sliced plots into a cylinder and then into rectangular 2D plots. Alternatively, the Cone operator can leave the sliced plots in 3D space where their cone shape is obvious. To set the cone projection mode, click on one of the following radio buttons: In 3D, Project to 2D, or Cylindrical.